Search results
Results from the WOW.Com Content Network
For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including: Internal hex drive: ISO 2936:2014 "Assembly tools for screws and nuts—Hexagon socket screw keys" [5] External hex drive: ISO 4014, 4016, 4017, and 4018 [6]
socket head cap screw: A cap screw with a socket head (usually implying a hex socket, driven with a hex key. SHN: shown: See Part number > Symmetrical parts for explanation. SHSS: socket head set screw: A set screw with a socket head (usually implying a hex socket, driven with a hex key. SI: Système international [d'unités] [International ...
In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...
Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt.
A can wrench is a wrench made to open a telephone distribution terminal also called a telco can or demarcation point box. One end of the can wrench is a 7/16 inch hex socket used for recessed fasteners on closures, and the other end is a 3/8 inch hex socket for use on binding posts.
Both the tool and socket have a slight taper. The contemporary square drive screw has all but replaced the Robertson screw proper and is commonly referred to as a Robertson because it has practically identical drive dimensions and the same colour identification system, but the contemporary square drive socket has parallel sides rather than tapered.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25).
At present the table in the Hex key standard sizes is taken from the "Machinery's Handbook, 26th Edition, section "Fasteners", chapter "Cap and Set Screws", table 4 (p. 1601)." That seems like a decent WP:RS but I'm wondering if the table should in include other sizes and that we find another WP:RS similar to the Machinery's Handbook.