enow.com Web Search

  1. Ads

    related to: toilet connections for water supply

Search results

  1. Results from the WOW.Com Content Network
  2. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.

  3. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [20] Because of the dual connection, it must be designed to resist the accidental backflow of contaminated water.

  4. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

  5. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

  6. Uniform Plumbing Code - Wikipedia

    en.wikipedia.org/wiki/Uniform_Plumbing_Code

    New alternate water sources for nonpotable applications and nonpotable rainwater catchment systems (Chapters 16, 17) based upon IAPMO’s Green Plumbing and Mechanical Code Supplement New Appendix L (sustainable practices) New minimum plumbing facilities table (Chapter 4) Water supply and drainage joint connection requirements (Chapters 6, 7) [12]

  7. Improved sanitation - Wikipedia

    en.wikipedia.org/wiki/Improved_sanitation

    To allow for international comparability of estimates for monitoring the Millennium Development Goals (MDGs), the Joint Monitoring Program (JMP) for Water Supply and Sanitation defines "improved" sanitation as the following kind of toilets: [5] Flush toilet; Connection to a piped sewer system; Connection to a septic system

  1. Ads

    related to: toilet connections for water supply