Search results
Results from the WOW.Com Content Network
This is often called the CMOS battery or BIOS battery. The original IBM AT through to the PS/2 range, used a relatively large primary lithium battery, compared to later models, to retain the clock and configuration memory. [2] These early machines required the backup battery to be replaced periodically due to the relatively large power consumption.
Some computer designs have used non-button cell batteries, such as the cylindrical "1/2 AA" used in the Power Mac G4 as well as some older IBM PC compatibles, or a 3-cell nickel–cadmium (Ni–Cd) CMOS battery that looks like a "barrel" (common in Amiga and older IBM PC compatibles), which serves the same purpose. These motherboards often have ...
Smart Battery System (SBS) is a specification for managing a smart battery, usually for a portable computer. It allows operating systems to perform power management operations via a smart battery charger based on remaining estimated run times by determining accurate state of charge readings. Through this communication, the system also controls ...
Typical POST screen (AMI BIOS) Typical UEFI-compliant BIOS POST screen (Phoenix Technologies BIOS) Summary screen after POST and before booting an operating system (AMI BIOS) A power-on self-test ( POST ) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on.
The 65C02 is a low cost, general-purpose 8-bit microprocessor (8-bit registers and data bus) with a 16-bit program counter and address bus.The register set is small, with a single 8-bit accumulator (A), two 8-bit index registers (X and Y), an 8-bit status register (P), and a 16-bit program counter (PC).
RF CMOS is also used in the radio transceivers for wireless standards such as GSM, Wi-Fi, and Bluetooth, transceivers for mobile networks such as 3G, and remote units in wireless sensor networks (WSN). [25] RF CMOS technology is crucial to modern wireless communications, including wireless networks and mobile communication devices.
CMOS inverter (a NOT logic gate). Complementary metal–oxide–semiconductor (CMOS, pronounced "sea-moss ", / s iː m ɑː s /, /-ɒ s /) is a type of metal–oxide–semiconductor field-effect transistor (MOSFET) fabrication process that uses complementary and symmetrical pairs of p-type and n-type MOSFETs for logic functions. [1]
Some of the advantages of CMOS fabrication, for example very low cost in mass production, do not transfer directly to BiCMOS fabrication. An inherent difficulty arises from the fact that optimizing both the BJT and MOS components of the process is impossible without adding many extra fabrication steps and consequently increased process cost and reduced yield.