Search results
Results from the WOW.Com Content Network
Bolt Shut-off Nozzle type BHP - pneumatic or hydraulic actuation. A shut-off bolt, positioned perpendicular to the melt channel moves up and down according to actuation, and thus shuts off/opens the melt flow. This nozzle type has a single melt channel. It therefore does not require rerouting of the melt around the shut-off mechanism.
Air-aspirating nozzles use an opening in the cone shaped nozzle to inject air into a stream of water based foam (CAFS/AFFF/FFFP) to make the concentrate "foam up". Most commonly found on foam extinguishers and foam handlines. Swirl nozzles inject the liquid in tangentially, and it spirals into the center and then exits through the central hole ...
Typical plug-nozzle garden sprayer with a trigger-pull lever (at the back) to control the position of the plug and valve. Common garden hose trigger nozzles are a simple example of the plug nozzle and its method of operation. In this example the nozzle consists of a conical or bell shaped opening with a plug on a movable rod positioned in front ...
Spray nozzles can have one or more outlets; a multiple outlet nozzle is known as a compound nozzle. Multiple outlets on nozzles are present on spray balls, which have been used in the brewing industry for many years for cleaning casks and kegs. [2] Spray nozzles range from those for heavy duty industrial uses to light duty spray cans or spray ...
A Med-E-Jet vaccination gun from 1980. A jet injector, also known as a jet gun injector, air gun, or pneumatic injector, is a medical instrument that uses a high-pressure jet of liquid medication to penetrate the skin and deliver medication under the skin without a needle. Jet injectors can be single-dose or multi-dose.
A fog nozzle. A fog nozzle is a firefighting hose spray nozzle that breaks its stream into small droplets.By doing so, its stream achieves a greater surface area, and thus a greater rate of heat absorption, which, when compared to that of a smoothbore nozzle, speeds its transformation into the steam that smothers the fire by displacing its oxygen.
The example shown is pneumatic. At sub-millimeter distances, a small movement of the flapper plate results in a large change in flow. The nozzle is fed from a chamber which is in turn fed by a restriction, so changes of flow result in changes of chamber pressure. The nozzle diameter must be larger than the restriction orifice in order to work. [2]
While research into this nozzle continues, it could be used before all its advantages are developed. As an upper stage, where it would be used in a low ambient pressure/vacuum environment specifically in closed wake mode, an E-D nozzle would offer weight reductions, length reductions and a potential increase to the specific impulse over bell nozzles (depending on engine cycle) allowing ...