Search results
Results from the WOW.Com Content Network
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
In bird anatomy, the gape is the interior of the open mouth of a bird, and the gape flange is the region where the two mandibles join together at the base of the beak. [33] The width of the gape can be a factor in the choice of food. [34] The gape flange on this juvenile house sparrow is the yellowish region at the base of the beak.
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
Swimming birds have a wide sternum, walking birds have a long sternum, and flying birds have a sternum that is nearly equal in width and height. [19] The chest consists of the furcula (wishbone) and coracoid (collar bone) which, together with the scapula , form the pectoral girdle ; the side of the chest is formed by the ribs, which meet at the ...
The tongue makes an extremely broad contact across the roof of the mouth, making correlation with the places of articulation of non-clicks difficult, but Ladefoged & Traill (1984:18) find that the primary place of articulation is the palate, and say that "there is no doubt that [ǂ] should be described as a palatal sound".
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
Shed roof attached to a barn. A shed roof, also known variously as a pent roof, lean-to roof, outshot, catslide, skillion roof (in Australia and New Zealand), and, rarely, a mono-pitched roof, [1] is a single-pitched roof surface. This is in contrast to a dual- or multiple-pitched roof.