Search results
Results from the WOW.Com Content Network
Values are given in terms of temperature necessary to reach the specified pressure. Valid results within the quoted ranges from most equations are included in the table for comparison. A conversion factor is included into the original first coefficients of the equations to provide the pressure in pascals (CR2: 5.006, SMI: -0.875).
Although the relation between vapor pressure and temperature is non-linear, the chart uses a logarithmic vertical axis to produce slightly curved lines, so one chart can graph many liquids. A nearly straight line is obtained when the logarithm of the vapor pressure is plotted against 1/(T + 230) [8] where T is the temperature in degrees Celsius ...
The millimeter of mercury by definition is 133.322387415 Pa [5] (13.5951 g/cm 3 × 9.80665 m/s 2 × 1 mm), which is approximated with known accuracies of density of mercury and standard gravity. The torr is defined as 1 / 760 of one standard atmosphere, while the atmosphere is defined as 101325 pascals.
English: Plot of water vapor pressure p in Torr (mmHg) and hPa versus Temperature T in degrees Celsius. Note that the vapor pressure equals atmospheric pressure (760 Torr) at the boiling temperature of water. Produced by Yannick Trottier in 2006. Extended by Dr. Schorsch (talk) 10:32, 25 April 2021 (UTC).
The Antoine equation is a class of semi-empirical correlations describing the relation between vapor pressure and temperature for pure substances. The Antoine equation is derived from the Clausius–Clapeyron relation. The equation was presented in 1888 by the French engineer Louis Charles Antoine (1825–1897). [1]
The boiling point of water is the temperature at which the saturated vapor pressure equals the ambient pressure. Water supercooled below its normal freezing point has a higher vapor pressure than that of ice at the same temperature and is, thus, unstable. Calculations of the (saturation) vapor pressure of water are commonly used in meteorology.
This page was last edited on 12 November 2023, at 16:44 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
The correct result would be P = 101.325 kPa, the normal (atmospheric) pressure. The deviation is −1.63 kPa or −1.61 %. The deviation is −1.63 kPa or −1.61 %. It is important to use the same absolute units for T and T c as well as for P and P c .