Search results
Results from the WOW.Com Content Network
B-tiles can be related to such A-tiles in two ways: If B S has the same size as A L then B L is an enlarged version φ A S of A S, with side lengths (φ, φ, φ 2 = 1 + φ) – this decomposes into an A L tile and A S tile joined along a common side of length 1.
The ISO 128 replaced the previous DIN 6 standard for drawings, projections and views, which was first published in 1922 and updated in 1950 and 1968. ISO 128 itself was first published in 1982, contained 15 pages and "specified the general principles of presentation to be applied to technical drawings following the orthographic projection methods".
A size chart illustrating the ANSI sizes. In 1992, the American National Standards Institute adopted ANSI/ASME Y14.1 Decimal Inch Drawing Sheet Size and Format, [1] which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in "letter" size to which it assigned the designation "ANSI A".
Non-shrink grout being applied to tiles. Non-shrink grout is a hydraulic cement grout that, when hardened under stipulated test conditions, does not shrink, so its final volume is greater than or equal to the original installed volume. It is often used as a transfer medium between load-bearing members.
Structural clay tiles are manufactured in a variety of standard sizes, including 4 inches (10 cm), 6 inches (15 cm), 8 inches (20 cm), 10 inches (25 cm) and 12 inches (30 cm)thicknesses, and typically 12 inches (30 cm) x 12 inches (30 cm) or 12 inches (30 cm) x 8 inches (20 cm) face dimensions. [5] Tile was also manufactured in a series of ...
Grout sealer is a water-based or solvent-based sealant applied over dried grout that resists water, oil, and acid-based contaminants. Grout cleaner is a basic cleaning solution that is applied on grout lines and removes the dirt and dust. [9] A die grinder is used for faster removal of old grout compared to a standard grout saw.
For floors, quarry tile is usually set in a thick bed of cementitious mortar. For wall applications, it can be set in either a thick bed of cementitious mortar or a thin bed of mastic. For both floors and walls, the joints between tiles are usually grouted with cementitious grout. Grout joints are traditionally about 3 ⁄ 8 inch in width
CAD standards are a set of guidelines for the appearance of computer-aided design (CAD) drawings should appear, to improve productivity and interchange of CAD documents between different offices and CAD programs, especially in architecture and engineering.