Search results
Results from the WOW.Com Content Network
The Chevrolet 90° V6 family of V6 engines began in 1978 with the Chevrolet 200 cu in (3.3 L) as the base engine for the all new 1978 Chevrolet Malibu.The original engine family was phased out in early 2014, with its final use as the 4.3 L (262 cu in) V6 engine used in Chevrolet and GMC trucks and vans.
The 6 cylinder version produced about 120 hp (89.5 kW) and was tested in a Corvair, while 2 and 4 cylinder engines were installed in a Renault Caravelle and two Alfa Romeo Giuliettas. The 10 cylinder version was called P-10 and was installed in a 1962 Chevrolet Impala converted to front-wheel drive. This engine produced 200 hp (149.1 kW).
78 = 200 V6 (95 hp), 231 (3.8 ... and limited variable valve timing. The 3.5 L V6 was offered as an upgrade for special-order fleet vehicles, to replace the Ecotec ...
The engine produced 200 hp (149 kW; 203 PS) at 5000 rpm and 229 lb⋅ft (310 N⋅m) of torque at 2500–4000 rpm. The engine was unique in that it used asymmetrical turbocharging, with the turbocharger driven by the exhaust gases from only one bank of cylinders. A charge pressure of 3.6 psi (0.25 bar) was produced using a Garrett GT15 turbo.
An updated version of the Generation III 3400 engine. It includes a new block, intake manifold, oil pan, engine cover, and fuel system, as well as electronic throttle control. [11] It was built in China and shipped to Canada for installation in the Chevrolet Equinox and Pontiac Torrent. The LNJ makes 185 hp (138 kW) and 210 lb⋅ft (285 N⋅m ...
The LT1 uses a new engine block, cylinder head, timing cover, water pump, intake manifold and accessory brackets. The harmonic damper also does not interchange; it is a unique damper/pulley assembly. Engine mounts and bell housing bolt pattern remain the same, permitting a newer engine to be readily swapped into an older vehicle.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.