Ads
related to: calibration requirements for vessels
Search results
Results from the WOW.Com Content Network
This page refers exclusively to oily water separators aboard marine vessels. They are found on board ships where they are used to separate oil from oily waste water such as bilge water before the waste water is discharged into the environment. These discharges of waste water must comply with the requirements laid out in Marpol 73/78. [1]
NIST certification of a flowmeter lab means that its methods have been approved by NIST. Normally, this includes NIST traceability, meaning that the standards used in the flowmeter calibration process have been certified by NIST or are causally linked back to standards that have been approved by NIST. However, there is a general belief in the ...
A dead weight tester (DWT) is a calibration standard method that uses a piston cylinder on which a load is placed to make an equilibrium with an applied pressure underneath the piston. Deadweight testers are secondary standards which means that the pressure measured by a deadweight tester is defined through other quantities: length, mass and ...
ISO/IEC 17025 General requirements for the competence of testing and calibration laboratories is the main standard used by testing and calibration laboratories. In most countries, ISO/IEC 17025 is the standard for which most labs must hold accreditation in order to be deemed technically competent.
The Pressure Equipment Directive (PED) 2014/68/EU (formerly 97/23/EC) [1] of the EU sets out the standards for the design and fabrication of pressure equipment ("pressure equipment" means steam boilers, pressure vessels, piping, safety valves and other components and assemblies subject to pressure loading) generally over one liter in volume and having a maximum pressure more than 0.5 bar gauge.
In order to comply with the ISM Code, the Company operating the vessel has to be audited first (after they submit their Safety Management System Manual (SMS) and is approved by Flag Administration or Recognized Organization (RO). Once a Company is Audited, the Document of Compliance (DOC) will be issued (validity 5 years). Every Company is ...
These standards were updated various but the most current resolution is MEPC 108(49). The oil content meter will sound an alarm if the liquid leaving the system has an unsatisfactory amount of oil in the mixture. If it is still above that standard, then the bilge water will be reentered into the system until it meets the required criteria.
Vessel safety surveys are inspections of the structure and equipment of a vessel to assess the condition of the surveyed items and check that they comply with legal or classification society requirements for insurance and registration. They may occur at any time when there is reason to suspect that the condition has changed significantly since ...
Ads
related to: calibration requirements for vessels