enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

3. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   Number drill bit gauge sizes range from size 80 (the smallest) to size 1 (the largest) followed by letter gauge size A (the smallest) to size Z (the largest). Although the ASME B94.11M twist drill standard, for example, lists sizes as small as size 97, sizes smaller than 80 are rarely encountered in practice.

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   One advantage over the Phillips drive is that one driver or bit fits all screw sizes. It is often found in marine hardware and requires a Frearson screwdriver or bit to work properly. The tool recess is a perfect, sharp cross, allowing for higher applied torque, unlike the rounded, tapered Phillips head, which can cam out at high torque. It was ...

5. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   Due to its design, a single bit can be used for drilling a wide range of hole sizes. Some bits come to a point and are thus self-starting. The larger-size bits have blunt tips and are used for hole enlarging. Unibits are commonly used on sheet metal [11] and in general construction. One drill bit can drill the entire range of holes necessary on ...

6. Yankee screwdriver - Wikipedia

   en.wikipedia.org/wiki/Yankee_screwdriver

   Drill points for the smallest 133/135 size screwdriver; adapters to adapt push drill size drill point sets to the three sizes of screwdriver chuck size; countersinks; screwdriver tips holding with screw holding feature; Phillips screwdriver tips in various sizes (Ph#1 to Ph#3 in 5/16" and 9/32" shank models, Ph#1 and Ph#2 sizes only for the 7/ ...

7. Screwdriver - Wikipedia

   en.wikipedia.org/wiki/Screwdriver

   Proper use requires that the screwdriver's tip engage the head of a screw of the same size and type designation as the screwdriver tip. Screwdriver tips are available in a wide variety of types and sizes (List of screw drives). The two most common are the simple 'blade'-type for slotted screws, and Phillips, generically called "cross-recess ...