Search results
Results from the WOW.Com Content Network
A sieve analysis (or gradation test) is a practice or procedure used in geology, civil engineering, [1] and chemical engineering [2] to assess the particle size distribution (also called gradation) of a granular material by allowing the material to pass through a series of sieves of progressively smaller mesh size and weighing the amount of material that is stopped by each sieve as a fraction ...
Although such information contains long lists of sieve sizes, in practice sieves are normally used in series in which each member sieve is selected to pass particles approximately 1/ √ 2 smaller in diameter or 1/2 smaller in cross-sectional area than the previous sieve. For example the series 80mm, 63, 40, 31.5, 20, 16, 14, 10, 8, 6.3, 4, 2.8 ...
The Fineness Modulus (FM) is an empirical figure obtained by adding the total percentage of the sample of an aggregate retained on each of a specified series of sieves, dividing the sum by 100. Sieves sizes are: 150-μm (No. 100), 300-μm (No. 50), 600-μm (No. 30), 1.18-mm (No. 16), 2.36-mm (No. 8), 4.75-mm (No. 4), 9.5-mm (3/8-in.), 19.0-mm ...
PSD is usually defined by the method by which it is determined. The most easily understood method of determination is sieve analysis, where powder is separated on sieves of different sizes. Thus, the PSD is defined in terms of discrete size ranges: e.g. "% of sample between 45 μm and 53 μm", when sieves of these sizes are used.
more than 50% retained on or above No.200 (0.075 mm) sieve: gravel > 50% of coarse fraction retained on No.4 (4.75 mm) sieve clean gravel <5% smaller than No.200 Sieve GW well-graded gravel, fine to coarse gravel GP poorly graded gravel gravel with >12% fines GM silty gravel GC clayey gravel sand
Grain size (or particle size) is the diameter of individual grains of sediment, or the lithified particles in clastic rocks. The term may also be applied to other granular materials . This is different from the crystallite size, which refers to the size of a single crystal inside a particle or grain.
The complete test requires 500 drum revolutions at a speed of 30-33 revolutions per minute. [6] Crushed sample is then separated from fine dust on a sieve, washed, dried and weighed. [6] The test reports loss of mass to abrasion and impact, expressed as a percentage of initial sample mass. [7]
Particle size is a notion introduced for comparing dimensions of solid particles (), liquid particles (), or gaseous particles ().The notion of particle size applies to particles in colloids, in ecology, in granular material (whether airborne or not), and to particles that form a granular material (see also grain size).