Search results
Results from the WOW.Com Content Network
When measurements started to be used in reviews of consumer equipment in the late 1960s, it became apparent that they did not always correlate with what was heard. In particular, the introduction of Dolby B noise reduction on cassette recorders was found to make them sound a full 10.2 dB less noisy, yet they did not measure 10.2 dB better ...
Cassette noise, which was predominately high frequency and unavoidable given the small size and speed of the recorded track could be made subjectively much less important. The noise sounded 10 dB quieter, but failed to measure much better unless 468-weighting was used rather than A-weighting.
The human ear responds quite differently to clicks and bursts of random noise, and it is this difference that gave rise to the CCIR-468 weighting curve (now supported as an ITU standard), which together with quasi-peak measurement (rather than the rms measurement used with A-weighting) became widely used by broadcasters throughout Britain ...
Loudspeaker measurement is the practice of determining the behaviour of loudspeakers by measuring various aspects of performance. This measurement is especially important because loudspeakers, being transducers, have a higher level of distortion than other audio system components used in playback or sound reinforcement.
Dynamic range is a measure of how small you can measure a signal relative to the maximum input signal the device can measure. Expressed in decibels, the dynamic range is 20 log (Vmax/Vmin). For example, a device with an input range of ±10 V and a dynamic range of 110 dB will be able to measure a signal as small as 10 μV.
Noise curves are a common way to characterise background noise in unoccupied buildings and spaces. [1] Their purpose is to produce a single-value representation of a complete sound spectrum. International standards organizations ( ISO , [ 2 ] ANSI [ 3 ] and ASA ) recognize the need to objectify judgements on the amount of ambient noise in ...
A recording is made with the low frequencies reduced and the high frequencies boosted, and on playback, the opposite occurs. The net result is a flat frequency response, but with attenuation of high-frequency noise such as hiss and clicks that arise from the recording medium. Reducing the low frequencies also limits the excursions the cutter ...
Signal-to-noise ratio (SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. SNR is defined as the ratio of signal power to noise power , often expressed in decibels .