Search results
Results from the WOW.Com Content Network
QBD is the term applied to the charge-to-breakdown measurement of a semiconductor device. It is a standard destructive test method used to determine the quality of gate oxides in MOS devices. It is equal to the total charge passing through the dielectric layer (i.e. electron or hole fluence multiplied by the elementary charge) just before failure.
The test often reveals problems that occurred during assembly, such as defective components, improper component placement, and insulator defects that may cause inadvertent shorting or grounding to chassis, in turn, compromising electrical circuit quality and product safety.
IEC 60172 Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires; IEC 60183 Guidance for the selection of high-voltage A.C. cable systems; IEC 60188 High-pressure mercury vapour lamps – Performance specifications; IEC 60189 Low-frequency cables and wires with PVC insulation and PVC sheath
Coulometry is the measure of charge, thus named after its unit the coulomb. Michael Faraday, known for his work in electricity and magnetism, made critical contributions to the field of electrochemistry. He discovered the laws of electrolysis, and in his recognition is the eponym of the Faraday constant.
Battery tester. A battery tester is an electronic device intended for testing the state of an electric battery, going from a simple device for testing the charge actually present in the cells and/or its voltage output, to a more comprehensive testing of the battery's condition, namely its capacity for accumulating charge and any possible flaws affecting the battery's performance and security.
In a peristaltic charge-coupled device, the charge-packet transfer operation is analogous to the peristaltic contraction and dilation of the digestive system. The peristaltic CCD has an additional implant that keeps the charge away from the silicon/silicon dioxide interface and generates a large lateral electric field from one gate to the next ...
The charge control consists of a pressure switch built into the cell, which disconnects the charging current when the internal cell pressure rises above a certain limit; usually 200 pounds per square inch (1.4 MPa) to 300 pounds per square inch (2.1 MPa). This prevents overcharging and damage to the cell.
Variations in the electrical conductivity and magnetic permeability of the test object, and the presence of defects causes a change in eddy current and a corresponding change in phase and amplitude that can be detected by measuring the impedance changes in the coil, which is a telltale sign of the presence of defects. [5]