Search results
Results from the WOW.Com Content Network
A chemical equation is the symbolic representation of a chemical reaction in the form of symbols and chemical formulas.The reactant entities are given on the left-hand side and the product entities are on the right-hand side with a plus sign between the entities in both the reactants and the products, and an arrow that points towards the products to show the direction of the reaction. [1]
An element–reaction–product table is used to find coefficients while balancing an equation representing a chemical reaction. Coefficients represent moles of a substance so that the number of atoms produced is equal to the number of atoms being reacted with. [1] This is the common setup: Element: all the elements that are in the reaction ...
Equations should be balanced according to the stoichiometry, the number of atoms of each species should be the same on both sides of the equation. This is achieved by scaling the number of involved molecules (A, B, C and D in a schematic example below) by the appropriate integers a, b, c and d .
In chemistry, a reaction intermediate, or intermediate, is a molecular entity arising within the sequence of a stepwise chemical reaction.It is formed as the reaction product of an elementary step, from the reactants and/or preceding intermediates, but is consumed in a later step.
An excess reactant is a reactant that is left over once the reaction has stopped due to the limiting reactant being exhausted. Consider the equation of roasting lead(II) sulfide (PbS) in oxygen (O 2) to produce lead(II) oxide (PbO) and sulfur dioxide (SO 2): 2 PbS + 3 O 2 → 2 PbO + 2 SO 2
In the following chemical equation, arrows point both ways to indicate equilibrium. [5] A and B are reactant chemical species, S and T are product species, and α, β, σ, and τ are the stoichiometric coefficients of the respective reactants and products: α A + β B ⇌ σ S + τ T
If the products are higher in chemical energy than the reactants then the reaction will require energy to be performed and is therefore an endergonic reaction. Additionally if the product is less stable than a reactant, then Leffler's assumption holds that the transition state will more closely resemble the product than the reactant. [6]
Conversion and its related terms yield and selectivity are important terms in chemical reaction engineering.They are described as ratios of how much of a reactant has reacted (X — conversion, normally between zero and one), how much of a desired product was formed (Y — yield, normally also between zero and one) and how much desired product was formed in ratio to the undesired product(s) (S ...