Search results
Results from the WOW.Com Content Network
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
Size of this PNG preview of this SVG file: ... English: Measuring tape diagram showing fractions of a inch in 1/2, 1/4, 1/8 and 1/16ths. Date: 23 July 2015: Source ...
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
But with body jewelry, there is a wide variety of possible sizes, and wearers generally want jewelry that is the same size as their piercing site. Some wearers want increasingly larger sizes to deliberately stretch the hole. So that wearers can choose the size they want, there are standards for body jewelry sizes, used by jewelry makers and ...
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
It is customary when measuring in hands to use a point to indicate inches (quarter-hands) and not tenths of a hand. For example, 15.1 hands normally means 15 hands, 1 inch (5 ft 1 in), rather than 15 + 1 ⁄ 10 hands. [5]
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
The diameters are sometimes given approximately in fractions of an inch (e.g. the major diameter of a #6 screw is 0.1380 in, approximately 9 ⁄ 64 in = 0.140625 in. The pitch P is the distance between thread peaks.