Search results
Results from the WOW.Com Content Network
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
Material removal rate (MRR) is the amount of material removed per time unit (usually per minute) when performing machining operations such as using a lathe or milling machine. The more material removed per minute, the higher the material removal rate. [1] [2] The MRR is a single number that enables you to do this. It is a direct indicator of ...
These multi-component forces are measured as an individual component force in each co-ordinate, depending on the coordinate system used. The forces during machining are dependent on depth of cut, feed rate, cutting speed, tool material and geometry, material of the work piece and other factors such as use of lubrication/cooling during machining.
In machining, the rake angle is a parameter used in various cutting processes, describing the angle of the cutting face relative to the workpiece. There are three types of rake angles: positive, zero or neutral, and negative. Positive rake: A tool has a positive rake when the face of the cutting tool slopes away from the cutting edge at inner side.
Center gauges and fishtail gauges [1] are gauges used in lathe work for checking the angles when grinding the profiles of single-point screw-cutting tool bits and centers. In the image, the gauge on the left is called a fishtail gauge or center gauge, and the one on the right is another style of center gauge. [2]
Crater wear occurs approximately at a height equalling the cutting depth of the material. Crater wear depth (t 0) = cutting depth; Notch wear which happens on both the insert rake and flank face along the depth of cut line causing localised damage to it primarily due to pressure welding of the chips. The chips literally get welded to the insert.
Both standard and non-standard screw threads can be turned on a lathe using an appropriate cutting tool. (Usually having a 60, or 55° nose angle) Either externally, or within a bore (tapping operation is a process of making threads either inner or outer in an work piece. [ 4 ]
Machinability is the ease with which a metal can be cut permitting the removal of the material with a satisfactory finish at low cost. [1] Materials with good machinability (free machining materials) require little power to cut, can be cut quickly, easily obtain a good finish, and do not cause significant wear on the tooling.