Search results
Results from the WOW.Com Content Network
Reasons for measuring throughput in networks. People are often concerned about measuring the maximum data throughput in bits per second of a communications link or network access. A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or ...
The asymptotic throughput (less formal asymptotic bandwidth) for a packet-mode communication network is the value of the maximum throughput function, when the incoming network load approaches infinity, either due to a message size, [3] or the number of data sources.
Link throughput ≈ Bitrate × Transmission time / roundtrip time. The message delivery time or latency over a network depends on the message size in bit, and the network throughput or effective data rate in bit/s, as: Message delivery time = Message size / Network throughput
Throughput is controlled by available bandwidth, as well as the available signal-to-noise ratio and hardware limitations. Throughput for the purpose of this article will be understood to be measured from the arrival of the first bit of data at the receiver, to decouple the concept of throughput from the concept of latency.
Network performance could be measured using either active or passive techniques. Active techniques (e.g. Iperf) are more intrusive but are arguably more accurate. Passive techniques have less network overhead and hence can run in the background to be used to trigger network management actions.
In computer networks, goodput (a portmanteau of good and throughput) is the application-level throughput of a communication; i.e. the number of useful information bits delivered by the network to a certain destination per unit of time. The amount of data considered excludes protocol overhead bits as well as retransmitted data packets. This is ...
iperf, Iperf, or iPerf, is a tool for network performance measurement and tuning. It is a cross-platform tool that can produce standardized performance measurements for any network. iperf has client and server functionality, and can create data streams to measure the throughput between the two ends in one or both directions. [2]
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...