Search results
Results from the WOW.Com Content Network
Pages in category "Rotating shaft couplings" The following 20 pages are in this category, out of 20 total. This list may not reflect recent changes. ...
An improvised flexible coupling made of car tyre pieces connects the drive shafts of an engine and a water pump. This one is used to cancel out misalignment and dampen vibrations. Rotating coupling. A coupling is a device used to connect two shafts together at their ends for the purpose of transmitting power. The primary purpose of couplings is ...
A Schmidt coupling is a type of coupling designed to accommodate large radial displacement between two shafts. Consisting of an arrangement of links and discs—three discs rotating in unison, interconnected in series by three or more links between each pair of discs—a Schmidt coupling can adapt to very wide variations in radial displacement while running under load.
A driveshaft coupling. Note the split damage beginning to appear, likely due to the large axial displacement. A giubo. A giubo (/ ˈ dʒ uː b oʊ / JOO-boh; etymology: giunto Boschi, "Boschi joint"), also known as a 'flexdisc', and sometimes misspelled as guibo, is a flexible coupling used to transmit rotational torque between the drive shaft and the companion flange on mechanical devices ...
The Geislinger coupling is an all-metal coupling for rotating shafts. It is elastic in torsion, allowing it to absorb torsional vibration. [1] Unlike some other coupling types, it is not intended to compensate for high radial misalignment between shafts, but it can compensate for axial misalignments better than elastomer couplings.
A universal joint (also called a universal coupling or U-joint) is a joint or coupling connecting rigid shafts whose axes are inclined to each other. It is commonly used in shafts that transmit rotary motion. It consists of a pair of hinges located close together, oriented at 90° to each other, connected by a cross shaft.
An animation of a Hobson joint. A Hobson's joint or Hobson's coupling is a type of right-angle constant-velocity joint; rods bent 90° are able to transmit torque around a corner because they are all free to turn in their mounting holes in both legs of the coupling.
The centre of a shaft is not toothed, as this would add little torque capacity to the coupling and the increasingly narrow teeth would become impractical to cut. For instance, a shaft of 60 mm diameter can be toothed in a 12 mm wide ring only (inner diameter is 36 mm) without jeopardizing the load-bearing capacity of the shaft. [citation needed]