Search results
Results from the WOW.Com Content Network
ATPG (acronym for both automatic test pattern generation and automatic test pattern generator) is an electronic design automation method or technology used to find an input (or test) sequence that, when applied to a digital circuit, enables automatic test equipment to distinguish between the correct circuit behavior and the faulty circuit behavior caused by defects.
The test vector is a collection of bits to apply to the circuit's inputs, and a collection of bits expected at the circuit's output. If the gate pin under consideration is grounded, and this test vector is applied to the circuit, at least one of the output bits will not agree with the corresponding output bit in the test vector.
ecu.test automates the control of the whole test environment and supports a broad range of test tools. Various abstraction layers for measured quantities allow its application on different testing levels, e.g. within the context of model in the loop, software in the loop and hardware in the loop as well as in real systems (vehicle and driver in the loop).
Test compression is a technique used to reduce the time and cost of testing integrated circuits.The first ICs were tested with test vectors created by hand. It proved very difficult to get good coverage of potential faults, so Design for testability (DFT) based on scan and automatic test pattern generation (ATPG) were developed to explicitly test each gate and path in a design.
The tests are generally driven by test programs that execute using automatic test equipment (ATE) or, in the case of system maintenance, inside the assembled system itself. In addition to finding and indicating the presence of defects (i.e., the test fails), tests may be able to log diagnostic information about the nature of the encountered ...
The following are used for stimulus of the circuit under test: Power supplies; Signal generator; Digital pattern generator; Pulse generator; Voltcraft M-3850 portable multimeter. The following analyze the response of the circuit under test: Oscilloscope (Displays voltage as it changes over time) Frequency counter (Measures frequency)
A digital pattern generator is a piece of electronic test equipment or software used to generate digital electronic stimuli. Digital electronics stimuli are a specific kind of electrical waveform varying between two conventional voltages that correspond to two logic states ("low state" and "high state", "0" and "1").
In computer science and engineering, a test vector is a set of inputs provided to a system in order to test that system. In software development , test vectors are a methodology of software testing and software verification and validation .