enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hard disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Hard_disk_drive_interface

   A data cable (top) and control cable (below) connecting a controller card and an ST-506 type HDD. Power cable not shown. The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data.

3. SATA - Wikipedia

   en.wikipedia.org/wiki/SATA

   A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...

4. Molex connector - Wikipedia

   en.wikipedia.org/wiki/Molex_connector

   The desktop computer hard-drive connector (AMP Mate-n-Lok 1-480424-0 power connector) is standard on all 5.25-inch floppy drives, 3.5-inch PATA and non-SCA SCSI disk drives; however, newer SATA disk drives employ a more advanced interconnection with 15 contacts. These advanced connection systems were first developed by Molex and other connector ...

5. SCSI connector - Wikipedia

   en.wikipedia.org/wiki/SCSI_connector

   The power connector was typically the same 4-pin female Molex connector used in many other internal computer devices. The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) "IDC header" which has two rows of pins, 0.1 inches apart.

6. U.2 - Wikipedia

   en.wikipedia.org/wiki/U.2

   U.3 (SFF-TA-1001) is built on the U.2 spec and uses the same SFF-8639 connector. A single "tri-mode" (PCIe/SATA/SAS) backplane receptacle can handle all three types of connections; the controller automatically detects the type of connection used. This is unlike U.2, where users need to use separate controllers for SATA/SAS and NVMe.

7. SATA Express - Wikipedia

   en.wikipedia.org/wiki/SATA_Express

   Mechanically, connectors on the host side retain their backward compatibility in a way similar to how USB 3.0 does it – the new host-side SATA Express connector is made by "stacking" an additional connector on top of two legacy standard SATA data connectors, which are regular SATA 3.0 (6 Gbit/s) ports that can accept legacy SATA devices.