Search results
Results from the WOW.Com Content Network
V.32 (11/88) is an ITU-T recommendation for a modem operating as full-duplex on a 4-wire circuit, or half-duplex on a two-wire circuit, allowing bidirectional data transfer at either 9.6 kbit/s or 4.8 kbit/s at a symbol rate of 2,400 baud instead of the 600 baud of the V.22 standards.
This communication is done via an Ethernet crossover cable as opposed to a PC to DCE (hub, switch, or bridge) communication which is done via an Ethernet straight cable. V.35 is a high-speed serial interface designed to support both higher data rates and connectivity between DTEs (data-terminal equipment) or DCEs (data-communication equipment ...
User at modem A issues a dial command: AT-Get the modem's ATtention; D-Dial; T-Touch-Tone; 12125550100-Call this number RING: Modem A begins dialing. Modem B's phone-line rings, and the modem reports the fact. ATA: Computer at modem B issues answer command. CONNECT: CONNECT: The modems connect, and both modems report "connect".
A satellite modem or satmodem is a modem used to ... The LNB is usually powered by the modem through the signal cable with 13 or 18 V ... RS-422, V.35, G ...
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
Fokker V.35, a German prototype World War I fighter aircraft; ITU-T V.35, a wideband modem standard; LG V35 ThinQ, a smartphone; Nissan Skyline V35, an automobile
A DOCSIS 3.0 cable modem A cable modem termination system (CMTS) A DOCSIS architecture includes two primary components: a cable modem located at the customer premises, and a cable modem termination system (CMTS) located at the CATV headend. [28] The customer PC and associated peripherals are termed customer-premises equipment (CPE). The CPE are ...
The new design dropped the onboard CPU. The modem connected to the card used a 15-pin D-shell connector—which exactly matched the PC's game connector. Both models were powered by the PC. The new modem was frequency agile, with a configuration utility that ran on the PC to set up US and DS frequencies.