Search results
Results from the WOW.Com Content Network
Control rods are usually used in control rod assemblies (typically 20 rods for a commercial PWR assembly) and inserted into guide tubes within the fuel elements. Control rods often stand vertically within the core. In PWRs they are inserted from above, with the control rod drive mechanisms mounted on the reactor pressure vessel head. In BWRs ...
In 2012, a probe was opened regarding some fraudulently-certified parts installed in five OPR-1000 reactors over a ten-year period. [6] Hanbit-5 and -6, which had a greater number of fraudulent parts, were shut down until the parts could be replaced, and Hanbit-3 and -4 and Hanul-3 were allowed remain on-line pending parts replacement. [ 6 ]
A reactor vessel head for a pressurized water reactor. This structure is attached to the top of the reactor vessel body. It contains penetrations to allow the control rod driving mechanism to attach to the control rods in the fuel assembly. The coolant level measurement probe also enters the vessel through the reactor vessel head.
The reactor head under inspection. Unit One is an 879 MWe pressurized water reactor supplied by Babcock & Wilcox. The reactor was shut down from 2002 until early 2004 for safety repairs and upgrades. In 2012 the reactor supplied 7101.700 GWh of electricity. [14]
The core thermal power was 626 MWt. The reactor vessel was rated to 1015 psia and measured 12 feet 2 inches (3.71 m) diameter and 42 feet (13 m) tall. Dresden 1 Nuclear Flow Diagram featured a secondary steam generator for load following. The reactor featured a dual cycle, with steam coming from both the stream drum and steam generators.
The reactor unit is coupled to direct-drive helium closed-cycle gas turbine which drives a generator to produce electricity. The nuclear core design is based upon a new conversion technique in which an initial "starter" section of the core provides the neutrons to convert fertile material (used nuclear fuel, thorium, or depleted uranium ) into ...
The AP1000 design traces its history to two previous designs, the AP600 and the System 80.. The System 80 design was created by Combustion Engineering and featured a two-loop cooling system with a single steam generator paired with two reactor coolant pumps in each loop that makes it simpler and less expensive than systems which pair a single reactor coolant pump with a steam generator in each ...
Donald C. Cook Nuclear Plant is a nuclear power plant located just north of the city of Bridgman, Michigan which is part of Berrien County, on a 650-acre (260 ha) site 11 miles south of St. Joseph, Michigan, United States.