Search results
Results from the WOW.Com Content Network
Torque; system unit code symbol or abbrev. notes conversion factor/N⋅m combinations Industrial: SI: Newton-metre: Nm N⋅m 1 Nm lbft; Nm lbfft; Non-SI metric: kilogram-metre: kgm kg·m 9.80665 Imperial & US customary: pound-foot: lbft lb⋅ft Pound-inch (lb.in) is also available 1.3558 Scientific: SI: newton metre: Nm N⋅m 1 Nm lbft; Nm ...
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
The table below provides conversions between common SI units ... The torque on shaft is 0.0053 N⋅m at 2 A because of the assumed radius of the rotor (exactly 1 m). ...
{{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in column 3 of the following tables. These are accepted as input by {{convert}} as the second and third unnamed parameters: {{convert|100|kg|lb}} → 100 kilograms (220 lb)
The torque limiting clutch is the part of the tool that limits the amount of torque being applied to the fastener at the receiving end of the tool. On simpler tools the clutch settings may be marked with arbitrary numbers (e.g., from 1 for the lowest available torque to 20 for the highest, without necessarily having a linear relationship with ...
Conversion of the Mach unit of speed depends on the altitude at which the speed is measured. That altitude should be specified either in feet (for example, |altitude_ft=10,000 ) or in metres (for example, |altitude_m=3,749 ).
Units for other physical quantities are derived from this set as needed. In English Engineering Units, the pound-mass and the pound-force are distinct base units, and Newton's Second Law of Motion takes the form = where is the acceleration in ft/s 2 and g c = 32.174 lb·ft/(lbf·s 2).
A conversion factor may be necessary when using different units of power or torque. For example, if rotational speed (unit: revolution per minute or second) is used in place of angular speed (unit: radian per second), we must multiply by 2 π radians per revolution.