Search results
Results from the WOW.Com Content Network
Due to the over solubility of the reservoir, transport of the drug follows the burst and lag mechanism. There is a high transfer rate of the drug when the patch makes contact with the skin, but as time increases a concentration gradient is established, meaning delivery of the drug settles to a constant rate.
Class III – low permeability, high solubility . Example: cimetidine; The absorption is limited by the permeation rate but the drug is solvated very fast. If the formulation does not change the permeability or gastro-intestinal duration time, then class I criteria can be applied. Class IV – low permeability, low solubility . Example: bifonazole
Drug permeability, together with drug aqueous solubility are the two parameters that define the fate of the active ingredient after oral administration and ultimately define its bioavailability. [1] When drug permeability is empirically measured in vitro , it is generally called apparent permeability (P app ) as its absolute value varies ...
The distribution of a drug between tissues is dependent on vascular permeability, regional blood flow, cardiac output and perfusion rate of the tissue and the ability of the drug to bind tissue and plasma proteins and its lipid solubility. pH partition plays a major role as well. The drug is easily distributed in highly perfused organs such as ...
Here, the green substance has a greater solubility in the lower layer than in the upper layer. The partition coefficient, abbreviated P, is defined as a particular ratio of the concentrations of a solute between the two solvents (a biphase of liquid phases), specifically for un-ionized solutes, and the logarithm of the ratio is thus log P.
The rate of passage depends on the pressure, concentration, and temperature of the molecules or solutes on either side, as well as the permeability of the membrane to each solute. Depending on the membrane and the solute, permeability may depend on solute size, solubility, properties, or chemistry.
The solubility of a specific solute in a specific solvent is generally expressed as the concentration of a saturated solution of the two. [1] Any of the several ways of expressing concentration of solutions can be used, such as the mass, volume, or amount in moles of the solute for a specific mass, volume, or mole amount of the solvent or of the solution.
The stablest crystalline polymorph has the lowest dissolution rate. Dissolution also differs between anhydrous and hydrous forms of a drug. Anhydrous forms often dissolve faster but sometimes are less soluble. Esterification is also used to control solubility. For example, stearate and estolate esters of drugs have decreased solubility in ...