Ad
related to: transistor 13003 datasheet diagramalldatasheet.com has been visited by 10K+ users in the past month
- Microcontroller(3,662)
A small computer on
a single integrated circuit
- Amplifier(26,236)
A device that increases
amplitude of an electrical signal
- Mosfet(66598)
Search Description : ' MOSFET'
Total: 1/3330 Pages
- Transistor(28,210)
Search Description : 'TRANSISTOR'
Total: 1/2,166 Pages
- Microcontroller(3,662)
Search results
Results from the WOW.Com Content Network
Size comparison of BJT transistor packages, from left to right: SOT-23, TO-92, TO-126, TO-3 3D model of TO-3 package. In electronics, TO-3 is a designation for a standardized metal semiconductor package used for power semiconductors, including transistors, silicon controlled rectifiers, and, integrated circuits.
The bipolar junction transistor, the first type of transistor to be mass-produced, is a combination of two junction diodes and is formed of either a thin layer of p-type semiconductor sandwiched between two n-type semiconductors (an n–p–n transistor), or a thin layer of n-type semiconductor sandwiched between two p-type semiconductors (a p ...
3D model of a TO-92 package, commonly used for small bipolar transistors. A bipolar junction transistor (BJT) is a type of transistor that uses both electrons and electron holes as charge carriers. In contrast, a unipolar transistor, such as a field-effect transistor (FET), uses only one kind of charge carrier.
Cross section of a GaAs/AlGaAs/InGaAs pHEMT Band diagram of GaAs/AlGaAs heterojunction-based HEMT, at equilibrium.. A high-electron-mobility transistor (HEMT or HEM FET), also known as heterostructure FET (HFET) or modulation-doped FET (MODFET), is a field-effect transistor incorporating a junction between two materials with different band gaps (i.e. a heterojunction) as the channel instead of ...
Common circuit diagram symbols (US ANSI symbols) An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may ...
In schematic diagrams, the word lines are usually horizontal, and the bit lines are usually vertical. The control store on some minicomputers was one or more programmable logic array chips. The "blank" PLA from the chip manufacturer came with a diode matrix or transistor matrix with a diode (or transistor) at every intersection.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
The g m of bipolar small-signal transistors varies widely, being proportional to the collector current. It has a typical range of 1 to 400 mS . The input voltage change is applied between the base/emitter and the output is the change in collector current flowing between the collector/emitter with a constant collector/emitter voltage.
Ad
related to: transistor 13003 datasheet diagramalldatasheet.com has been visited by 10K+ users in the past month