Search results
Results from the WOW.Com Content Network
The vast majority of vehicles manufactured after 1987 are fuel-injected: the injectors and high-pressure fuel pump immediately cease supplying fuel to the cylinders when the ignition is switched off. If the injector is damaged or dirty, a small amount of fuel can enter the chamber and be ignited, causing a sputter or two after the engine is ...
An overflow tank that runs dry may result in the coolant vaporizing, which can cause localized or general overheating of the engine. Severe damage may result if the vehicle is allowed to run over temperature. Failures such as blown head gaskets, and warped or cracked cylinder heads or cylinder blocks may be the result. Sometimes there will be ...
A fixed-pitch propeller aircraft will show a decrease in engine RPM, and perhaps run rough, when carburetor ice has formed. However, a constant-speed propeller aircraft will show a decrease in manifold pressure as power is reduced. [1] In light aircraft, the carburetor heat is usually manually controlled by the pilot.
Auto-ignition of engine oil droplets (Can be solved by using an oil catch tank) [3] Insufficient oil in the engine; Ignition timing too far advanced; Too much air/too little fuel (octane) to withstand pressures (too much air causes too much pressure for the octane to handle, too little fuel reduces the octane to handle the pressurized air) [5]
U.S. regulators are warning airlines to limit the use of an anti-icing system on Boeing 737 Max jets in dry air to avoid overheating engine-housing parts, which could cause them to break away from ...
An air-cooled engine uses all of this difference. In contrast, a liquid-cooled engine might dump heat from the engine to a liquid, heating the liquid to 135 °C (water's standard boiling point of 100 °C can be exceeded as the cooling system is both pressurised, and uses a mixture with antifreeze) which is then cooled with 20 °C air.
In an internal combustion engine, the expansion of the high-temperature and high-pressure gases produced by combustion applies direct force to some component of the engine. The force is typically applied to pistons (piston engine), turbine blades (gas turbine), a rotor (Wankel engine), or a nozzle . This force moves the component over a distance.
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.