Search results
Results from the WOW.Com Content Network
Improving operational efficiency begins with measuring it. Since operational efficiency is about the output to input ratio, it must be measured on both the input and output side. Quite often, company management is measuring primarily on the input side, e.g., the unit production cost or the man hours required to produce one unit.
Useful output energy is always lower than input energy. Efficiency of power plants, world total, 2008. Energy conversion efficiency (η) is the ratio between the useful output of an energy conversion machine and the input, in energy terms. The input, as well as the useful output may be chemical, electric power, mechanical work, light (radiation ...
The operational transconductance amplifier (OTA) is an amplifier that outputs a current proportional to its input voltage. Thus, it is a voltage controlled current source (VCCS). Three types of OTAs are single-input single-output, differential-input single-output, and differential-input differential-output (a.k.a. fully differential), [ 1 ...
If energy output and input are expressed in the same units, efficiency is a dimensionless number. [1] Where it is not customary or convenient to represent input and output energy in the same units, efficiency-like quantities have units associated with them. For example, the heat rate of a fossil fuel power plant may be expressed in BTU per ...
YIG multipliers using step recovery diodes may, for example, take an input frequency of 1 to 2 GHz and produce outputs up to 18 GHz. [1] Sometimes the frequency multiplier circuit will adjust the width of the impulses to improve conversion efficiency for a specific harmonic.
In a three-winding motor, two of the windings are acting as a motor, and the third winding is acting as a generator. Because two of the outputs are the same as the single phase input, their phase relationship is 180° [citation needed]. This leaves the synthesized phase to be +/-90° from the input terminals.
An HVDC thyristor valve tower 16.8 m tall in a hall at Baltic Cable AB in Sweden A battery charger is an example of a piece of power electronics. A PCs power supply is an example of a piece of power electronics, whether inside or outside of the cabinet. Power electronics is the application of electronics to the control and conversion of ...
A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .