enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. The 7 Best HDTV Antenna Amplifiers of 2023 For a Better Signal

   www.aol.com/lifestyle/best-high-definition-tv...

   8-Port TV Distribution Amplifier. For households with multiple TVs, the Antennas Direct 8-Port TV Distribution Amplifier can split a signal with no noticeable impact on signal quality.

3. Antenna amplifier - Wikipedia

   en.wikipedia.org/wiki/Antenna_amplifier

   In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...

4. Tower Mounted Amplifier - Wikipedia

   en.wikipedia.org/wiki/Tower_Mounted_Amplifier

   A Tower Mounted Amplifier (TMA), or Mast Head Amplifier (MHA), is a low-noise amplifier (LNA) mounted as close as practical to the antenna in mobile masts or base transceiver stations. A TMA reduces the base transceiver station noise figure (NF) and therefore improves its overall sensitivity ; in other words the mobile mast is able to receive ...

5. Television antenna - Wikipedia

   en.wikipedia.org/wiki/Television_antenna

   Outdoor antennas provide up to a 15 dB gain in signal strength and 15-20 dB greater rejection of ghost signals in analog TV. [6] Combined with a signal increase of 14 dB due to height and 11 dB due to lack of attenuating building walls, an outdoor antenna can result in a signal strength increase of up to 40 dB at the TV receiver. [6]

6. Diplexer - Wikipedia

   en.wikipedia.org/wiki/Diplexer

   None of the low band signal is transferred from the L port to the H port. In the real world, some power will be lost, and some signal power will leak to the wrong port. Television diplexer consisting of a high-pass filter (left) and a low-pass filter (right). The antenna cable is connected on the back to the screw terminals to the left of center.

7. Low-noise block downconverter - Wikipedia

   en.wikipedia.org/wiki/Low-noise_block_downconverter

   The microwave signal from the dish is picked up by a feedhorn on the LNB and is fed to a section of waveguide. One or more metal pins, or probes, protrude into the waveguide at right angles to the axis and act as antennas, feeding the signal to a printed circuit board inside the LNB's shielded box for processing. The lower frequency IF output ...