enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 3 mm scale - Wikipedia

   en.wikipedia.org/wiki/3_mm_scale

   3 mm scale, also known as 3 mm finescale, is a model railway scale of 3 mm : 1 ft (305 mm) used for British prototypes. Introduced as British TT gauge , it sits approximately halfway between British N gauge and OO gauge but is not as popular as either and there is no longer any mass manufacturer ready-to-run support.

3. Decimal - Wikipedia

   en.wikipedia.org/wiki/Decimal

   The numbers that may be represented in the decimal system are the decimal fractions. That is, fractions of the form a/10 n, where a is an integer, and n is a non-negative integer. Decimal fractions also result from the addition of an integer and a fractional part; the resulting sum sometimes is called a fractional number.

4. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).

5. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.

6. Fraction - Wikipedia

   en.wikipedia.org/wiki/Fraction

   Decimal fractions are commonly expressed using decimal notation in which the implied denominator is determined by the number of digits to the right of a decimal separator, the appearance of which (e.g., a period, an interpunct (·), a comma) depends on the locale (for examples, see Decimal separator). Thus, for 0.75 the numerator is 75 and the ...

7. Metric system - Wikipedia

   en.wikipedia.org/wiki/Metric_system

   In the SI system and generally in older metric systems, multiples and fractions of a unit can be described via a prefix on a unit name that implies a decimal (base-10), multiplicative factor. The only exceptions are for the SI-accepted units of time (minute and hour) and angle (degree, arcminute, arcsecond) which, based on ancient convention ...