Search results
Results from the WOW.Com Content Network
Seawater, or sea water, is water from a sea or ocean.On average, seawater in the world's oceans has a salinity of about 3.5% (35 g/L, 35 ppt, 600 mM). This means that every kilogram (roughly one liter by volume) of seawater has approximately 35 grams (1.2 oz) of dissolved salts (predominantly sodium (Na +
Brine (or briny water) is a high-concentration solution of salt (typically sodium chloride or calcium chloride) in water.In diverse contexts, brine may refer to the salt solutions ranging from about 3.5% (a typical concentration of seawater, on the lower end of that of solutions used for brining foods) up to about 26% (a typical saturated solution, depending on temperature).
At 20 °C (68 °F) one liter of water can dissolve about 357 grams of salt, a concentration of 26.3 percent by weight (% w/w). At 100 °C (212 °F) (the boiling temperature of pure water), the amount of salt that can be dissolved in one liter of water increases to about 391 grams, a concentration of 28.1% w/w.
In most open waters concentrations vary somewhat around typical values of about 3.5%; drinking seawater temporarily increases blood's NaCl concentration, which signals the kidney to excrete sodium. However, seawater's sodium concentration is above the kidney's maximum concentrating ability.
A sample of seawater from most locations with a chlorinity of 19.37 ppt will have a Knudsen salinity of 35.00 ppt, a PSS-78 practical salinity of about 35.0, and a TEOS-10 absolute salinity of about 35.2 g/kg. The electrical conductivity of this water at a temperature of 15 °C is 42.9 mS/cm. [6] [12]
The tables below present an example of an artificial seawater (35.00‰ of salinity) preparation devised by Kester, Duedall, Connors and Pytkowicz (1967). [1] The recipe consists of two lists of mineral salts, the first of anhydrous salts that can be weighed out, the second of hydrous salts that should be added to the artificial seawater as a solution.
The preparation of salt solutions often takes place in unsealed beakers. In this case the conductivity of purified water often is 10 to 20 times higher. A discussion can be found below. Typical drinking water is in the range of 200–800 μS/cm, while sea water is about 50 mS/cm [3] (or 0.05 S/cm).
Sea salt particle number concentration can reach 50 cm −3 or more with high winds (>10 m s −1), compared to ~10 cm −3 or less under moderate wind regimes. [3] Due to the dependence on wind speed, it could be expected that sea-salt particle production and its impacts on climate may vary with climate change .