Search results
Results from the WOW.Com Content Network
The resulting 'Knudsen salinities' are expressed in units of parts per thousand (ppt or ‰). The use of electrical conductivity measurements to estimate the ionic content of seawater led to the development of the scale called the practical salinity scale 1978 (PSS-78). [9] [10] Salinities measured using PSS-78 do not have units.
The salinity in isolated bodies of water can be considerably greater still – about ten times higher in the case of the Dead Sea. Historically, several salinity scales were used to approximate the absolute salinity of seawater. A popular scale was the "Practical Salinity Scale" where salinity was measured in "practical salinity units (PSU)".
The handling of salinity was one of the novelties in TEOS-10. It defines the relationship between Reference Salinity and Practical Salinity, Chlorinity or Absolute Salinity and accounts for the different chemical compositions by adding a regionally variable 𝛿SA (see Figure). [7]
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
The same percentage falls in a salinity range between 34 and 35 ppt (3.4–3.5%) (Pinet 1996). There is still quite a bit of variation, however. Surface temperatures can range from below freezing near the poles to 35 °C in restricted tropical seas, while salinity can vary from 10 to 41 ppt (1.0–4.1%).
For example, the conversion factor between a mass fraction of 1 ppb and a mole fraction of 1 ppb is about 4.7 for the greenhouse gas CFC-11 in air (Molar mass of CFC-11 / Mean molar mass of air = 137.368 / 28.97 = 4.74). For volume fraction, the suffix "V" or "v" is sometimes appended to the parts-per notation (e.g. ppmV, ppbv, pptv).
The absolute salinity is based on density, where it uses the mass off all non-H 2 O molecules. Conductivity-based salinity is calculated directly from conductivity measurements taken by (for example) buoys. [5] The GSW beta(SA,CT,p) function can calculate β when the absolute salinity (SA), conserved temperature (CT) and the pressure are known.