enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Panzergewinde - Wikipedia

   en.wikipedia.org/wiki/Panzergewinde

   An assortment of PG cable glands.Similar glands with DIN/ISO metric threads are also available. The Stahlpanzerrohrgewinde (German: [ˈʃtaːlˌpantsɐʁoːɐ̯.ɡəˌvɪndə], "steel conduit thread") standard for screw threads, more often called by the shortened Panzergewinde (German: [ˈpantsɐɡəˌvɪndə]), was a technical standard created in Germany and subsequently used in Switzerland ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...

4. Thermoplastic-sheathed cable - Wikipedia

   en.wikipedia.org/wiki/Thermoplastic-sheathed_cable

   4/1.5 mm 2 and 6/2.5 mm 2 have stranded conductors and a solid CPC (fixed high power equipment or sub-mains) 10/4 mm 2 and 16/6 mm 2 have stranded conductors and CPC (fixed high power equipment or sub-mains) In older properties (pre-1970) cable with imperial sizes are found, sometimes without CPC.

5. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   All DWV systems require various sized fittings and pipes which are measured by their internal diameter of both the pipes and the fittings which, and in most cases are Schedule 40 PVC wye's, tee's, elbows ranging from 90 degrees to 22.5 degrees for both inside diameter fitment (street) as well as outer diameter fitment (hub), repair and slip ...

6. North American Fire Hose Coupler Incompatibilities - Wikipedia

   en.wikipedia.org/wiki/North_American_Fire_Hose...

   At its annual convention at Dallas, TX, the NFPA formally adopted a standard with 2 + 1 ⁄ 2-inch hose with 7.5 threads per inch as the primary standard, with additional sizes of 3 and 3.5 inches (each with 6 threads per inch) and a 4.5 inch coupling with 4 threads per inch, with the fire hydrant standard specifying one 4.5 inch port and two 2 ...

7. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.