Ads
related to: splined shaft stock hub city
Search results
Results from the WOW.Com Content Network
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.
A set of sprockets (called a "cassette") is mounted onto a splined shaft of the freehub to engage the chain. The ratcheting mechanism is a part of the hub, in contrast to a freewheel, an older technology, which contains both the sprockets and a ratcheting mechanism in a single unit separate from the hub. In many high-end and midrange bicycles ...
Hirth joint made from anodized aluminum to show the meshing of the teeth Hirth joint (disassembled) between the semi-axles of a Campagnolo Ultra-Torque crankset. Face spline joints consist of a ring of radial splines or teeth milled or ground into the end faces of two rotary components such as a drive shaft and the hub of a wheel.
A short inner stub shaft is splined to the differential side gear and an outer stub shaft is splined to the front wheel hub. Each stub shaft has a yoke, or housing, to accommodate a universal joint, at each end of a connecting intermediate shaft. Universal joints let the shaft keep rotating while allowing for changes due to suspension movement ...
Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1.625" Pinion shaft splines: 10 or 29
These consist of a shaft at the hub, with an external screw thread, a straight external spline section and a tapered interface at the hub base. The wheel centers have internal splines and a matching taper to align and center them on the hub. The wheels are fastened to the hub by means of a winged, threaded nut, called a "knock-off" or "spinner."
Square keys are used for smaller shafts and rectangular faced keys are used for shaft diameters over 6.5 in (170 mm) or when the wall thickness of the mating hub is an issue. Set screws often accompany parallel keys to lock the mating parts into place. [3] The keyway is a longitudinal slot in both the shaft and mating part.
The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts. Dana offered two different limited slip differentials with the Dana 70, the "Power-Lok" and the "Trac-Lok."
Ads
related to: splined shaft stock hub city