Search results
Results from the WOW.Com Content Network
The early model C4 (1964–1969) used a .788-inch 24-spline input shaft, which was upgraded in 1970 to 26-spline and .839-inch. The upgrade also included a matching 26-spline clutch hub. In 1971, Ford went to a 26/24-spline input shaft, meaning the torque-converter side is 26-spline and the clutch hub is 24-spline.
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.
35 Spline axle shafts with a 1.5 in (38 mm) diameter; ... The new axle also came with disc brakes and a unique 8x170 mm (6.7 in) metric lug pattern. Options and ...
A split shaft PTO is mounted to the truck's drive shaft to provide power to the PTO. Such a unit is an additional gearbox that separates the vehicle's drive shaft into two parts: The gearbox-facing shaft which will transmit the power of the engine to the split shaft PTO; The axle-facing shaft which transmit the propelling power to the axle.
The following stresses are induced in the shafts. Shear stresses due to the transmission of torque (due to torsional load). Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft. Stresses due to combined torsional and bending loads.
Shaft angle. A shaft angle is the angle between the axes of two non-parallel gear shafts. In a pair of crossed helical gears, the shaft angle lies between the oppositely rotating portions of two shafts. This applies also in the case of worm gearing. In bevel gears, the shaft angle is the sum of the two
The input on the transfer case can also be changed to match the output shaft spline count. Rear-wheel-drive-only transmissions all have the same spline count on the output shaft, only 4x4 models are affected by differing spline count. Gear Ratios for the AW4: 1st: 2.80; 2nd: 1.53; 3rd: 1.00; 4th: 0.75 (23-spline, 0.705 21-spline) Models that ...
Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1.625" Pinion shaft splines: 10 or 29