Search results
Results from the WOW.Com Content Network
When modular connectors are used, the latch release of the connector should be on the ridge side of flat phone wire in order to maintain polarity. Though four wires are typically used in U.S. phone cabling, only two are necessary for telecommunication. In the event that a second line is needed, the other two are used.
Profinet implements the interfacing to peripherals. [1] [2] It defines the communication with field connected peripheral devices.Its basis is a cascading real-time concept. Profinet defines the entire data exchange between controllers (called "IO-Controllers") and the devices (called "IO-Devices"), as well as parameter setting and diagnosi
Strictly, Registered Jack refers to both the female physical connector (modular connector) and specific wiring patterns, but the term is often used loosely to refer to modular connectors regardless of wiring, gender, or use, commonly for telephone line connections, but also for Ethernet over twisted pair, resulting in confusion over the various ...
The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]
Initially 4-wire was used and many older installations still use it, then the 6-wire became the new standard, but the 4-wire has latterly been reissued to all Openreach technicians as part of cost savings. Modern 4-wire however is the same diameter as 6-wire to allow technicians to retain existing tacking guns and cable clips.
In Mode A, pins 1 and 2 (pair 3 in T568A wiring, pair 2 in T568B) form one side of the 48 V DC, and pins 3 and 6 (pair 2 in T568A, pair 3 in T568B) form the other side. These are the same two pairs used for data transmission in 10BASE-T and 100BASE-TX, allowing the provision of both power and data over only two pairs in such networks.
The first version of Profisafe was released as early as 1998. [4] A second version in 2005 also enabled use via the Ethernet-based Profinet. According to the PROFIBUS Nutzerorganisation e.V., by 2023 a total of almost 21,7 million devices with Profisafe will be placed on the market by the various manufacturers, and a further 2.8 million devices will be added each year. [5]
GG45 is a variant of ARJ45 that allows for cables terminated with male 8P8C (AKA RJ45) connectors to be plugged into GG45 jacks. However, GG45 cables cannot plug into 8P8C jacks as a protrusion on the socket is designed to activate a switch on the jack for the alternative contact positions.