Search results
Results from the WOW.Com Content Network
Proximity switches operate by the disturbance of an electromagnetic field, by capacitance, or by sensing a magnetic field. Rarely, a final operating device such as a lamp or solenoid valve is directly controlled by the contacts of an industrial limit switch, but more typically the limit switch is wired through a control relay, a motor contactor ...
A VR sensor used as a simple proximity sensor can determine the position of a mechanical link in a piece of industrial equipment. A crankshaft position sensor (in an automobile engine) is used to provide the angular position of the crankshaft to the engine control unit. The engine control unit can then calculate engine speed (angular velocity).
Thus, they can operate at much higher speeds than mechanical sensors, and their lifespan is not limited by mechanical failure (unlike potentiometers, electromechanical reed switches, [15] relays, or other mechanical switches and sensors). However, Hall sensors can be prone to thermal drift due to changes in environmental conditions and to time ...
The proximity pin, PP (also known as plug present), as shown in the SAE J1772 example pinout, describes the switch, S3, as being mechanically linked to the connector latch release actuator. During charging, the EVSE side connects the PP–PE loop via S3 and a 150 Ω R6; when opening the release actuator a 330 Ω R7 is added in the PP–PE loop ...
A position sensor is a sensor that detects an object's position. A position sensor may indicate the absolute position of the object (its location) or its relative position (displacement) in terms of linear travel, rotational angle or three-dimensional space. Common types of position sensors include the following: Capacitive displacement sensor
A reed switch has very low resistance when closed, typically as low as 0.05 ohms, whereas the Hall effect sensors can be in the hundreds of ohms. A reed switch requires only two wires whereas most solid-state devices require three wires. A reed switch can be said to require zero power to operate it.
Converting the sensor's electrical output (for example V) to the measured units (for example K) requires dividing the electrical output by the slope (or multiplying by its reciprocal). In addition, an offset is frequently added or subtracted. For example, −40 must be added to the output if 0 V output corresponds to −40 C input.
Remote photoelectric sensors used for remote sensing contain only the optical components of a sensor. The circuitry for power input, amplification, and output switching is located elsewhere, typically in a control panel. This allows the sensor, itself, to be very small. Also, the controls for the sensor are more accessible, since they may be ...