Search results
Results from the WOW.Com Content Network
The Chevrolet Gemini small-block engine is a dual-overhead cam (DOHC) V8 engine designed by General Motors.While technically a small-block engine because of its bore spacing of 4.4 inches, [1] [2] General Motors engineers do not consider it to be a part of the traditional Chevrolet small block lineage because of the substantial reworking, specialized development, and unique technical features ...
The Cosworth Vega engine was produced in 1975 and 1976 using the 2300 engine block. The engine was de-stroked to 3.16 inches (80 mm) giving 2.0 L; 121.7 cu in (1,994 cc), with a 16-valve aluminum cylinder head, double overhead cams , forged components and solid lifters. It produced 110 hp (82 kW) and 107 lb⋅ft (145 N⋅m).
This block is one of three displacements, 302/327/350, that underwent a crankshaft bearing diameter transformation for 1968 when the rod-journal size was increased from the 2 in (50.8 mm) diameter small-journal to a 2.1 in (53.3 mm) large-journal and a main-journal size that was increased from 2.3 in (58.4 mm) to 2.45 in (62.2 mm).
It was introduced in the 1948 two and a half ton and three ton Ford trucks and the 1949 Lincoln passenger cars. It was produced through the 1951 model year. In 1952 it was replaced in the Lincoln passenger cars and Ford three ton trucks with the Lincoln Y-block 317 cu in (5.2 L) overhead-valve V8. The two and a half ton Ford trucks got a 279 cu ...
As of Jan. 15, Ninja claims he now has a low taper fade — but whether the haircut is an accurate low taper fade seems to be up for debate in the comments.
Even with the benefit of today's technology (aftermarket rods and stroker cranks), the upper limit of a Y-block is about 348 cu in (5.7 L), while the Chevrolet could be modified well past the factory limit of 400 cu in (6.6 L). The result was the introduction in 1958 of the 332 CID "big block" Ford FE engine which ultimately grew to 428 cu in.
From 1977 onward, the 351W shared the same head casting as the 302, differing only in bolt hole diameters (7/16 inch for the 302, 1/2 inch for the 351W). Early blocks (casting ID C9OE-6015-B) had enough metal on bearing saddles 2, 3, and 4 for four-bolt mains, and as with all small-block Fords (SBFs), were superior in strength to most late ...
A crossflow T-head sidevalve engine The usual L-head arrangement Pop-up pistons may be used to increase compression ratio Flathead with Ricardo's turbulent head. A flathead engine, also known as a sidevalve engine [1] [2] or valve-in-block engine, is an internal combustion engine with its poppet valves contained within the engine block, instead of in the cylinder head, as in an overhead valve ...