enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fender Hot Rod DeVille - Wikipedia

   en.wikipedia.org/wiki/Fender_Hot_Rod_DeVille

   An external speaker jack is located next to the output tubes in the back and allows the signal to be heard out of both the amplifier itself and the speakers to which it is connected (which must have a 4- or 8-Ohm impedance). The DeVille features a 60-watt valve amplifier with three 12AX7 preamp valves and two 6L6 output valves. Its circuitry ...

3. Thiele/Small parameters - Wikipedia

   en.wikipedia.org/wiki/Thiele/Small_parameters

   American EIA standard RS-299A specifies that (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for ...

4. Electrical characteristics of dynamic loudspeakers - Wikipedia

   en.wikipedia.org/wiki/Electrical_characteristics...

   If a home hi-fi amplifier specifies 8 ohm or greater loads, care should be taken that loudspeakers with a lower impedance are not used, lest the amplifier be required to produce more current than it was designed to handle. Using a 4 ohm loudspeaker system on an amplifier specifying 8 ohms or greater could lead to amplifier failure.

5. Line level - Wikipedia

   en.wikipedia.org/wiki/Line_level

   Connecting a low-impedance load such as a loudspeaker (usually 4 to 8 Ω) to a line out will essentially short circuit the output circuit. Such loads are around 1/1000 the impedance a line out is designed to drive, so the line out is usually not designed to source the current that would be drawn by a 4 to 8 ohm load at normal line out signal ...

6. Output impedance - Wikipedia

   en.wikipedia.org/wiki/Output_impedance

   The actual output impedance for most devices is not the same as the rated output impedance. A power amplifier may have a rated impedance of 8 ohms, but the actual output impedance will vary depending on circuit conditions. The rated output impedance is the impedance into which the amplifier can deliver its maximum amount of power without failing.

7. Damping factor - Wikipedia

   en.wikipedia.org/wiki/Damping_factor

   The E-202 has a Speaker Damping Control which permits choice of three damping factors and induces maximum potential performance from any speaker. Damping factor with an 8 Ω load becomes more than 50 when this control is set to NORMAL. Likewise, it is 5 at MEDIUM position, and 1 at SOFT position. It enables choosing the speaker sound that one ...