enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Centrifugal compressor - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_compressor

   The simplest inlet to a centrifugal compressor is typically a simple pipe. Depending upon its use/application inlets can be very complex. They may include other components such as an inlet throttle valve, a shrouded port, an annular duct (see Figure 1.1), a bifurcated duct, stationary guide vanes/airfoils used to straight or swirl flow (see Figure 1.1), movable guide vanes (used to vary pre ...

3. File:Main components of a centrifugal compressor in isometric ...

   en.wikipedia.org/wiki/File:Main_components_of_a...

   Date: 22 November 2016: Source: Heinrich, Martin (2016-11-22) Genetic Optimization of Turbomachinery Components using the Volute of a Transonic Centrifugal Compressor as a Case Study (Dr.-Ing), Technische Universität Bergakademie Freiberg, archived from the original on 2021-12-07, page 5, Figure 2.1

4. Components of jet engines - Wikipedia

   en.wikipedia.org/wiki/Components_of_jet_engines

   Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...

5. Gas turbine engine compressors - Wikipedia

   en.wikipedia.org/wiki/Gas_turbine_engine_compressors

   On civil turbofans, the first stage of the LP compressor is often a single-stage fan. If the HP compressor pressure ratio exceeds about 4.5:1, then the unit will probably have variable geometry (i.e. variable stators) on the first few stages, to make the surge line on the compressor map more shallow, to accommodate the shallow working line.

6. Centrifugal-type supercharger - Wikipedia

   en.wikipedia.org/wiki/Centrifugal-type_supercharger

   Centrifugal supercharger components The four main components of a centrifugal supercharger are the volute (compressor housing), diffuser, impeller and transmission. Volutes are typically cast into a form from aluminum rather than other metals due to the combination of strength, weight, and resistance to corrosion.

7. Exploded-view drawing - Wikipedia

   en.wikipedia.org/wiki/Exploded-view_drawing

   An exploded-view drawing is a diagram, picture, schematic or technical drawing of an object, that shows the relationship or order of assembly of various parts. [1]It shows the components of an object slightly separated by distance, or suspended in surrounding space in the case of a three-dimensional exploded diagram.

8. Rotary-screw compressor - Wikipedia

   en.wikipedia.org/wiki/Rotary-screw_compressor

   Principal view of the pumping action of a twin-screw pump with a six-lobe female screw and a five-lobe male screw. A compressor (as opposed to a pump) would be shaped the same way, except that the shape of the lobes would change along the length of the screw, so that the volume of the trapped pockets would get squeezed smaller as they get closer to the exhaust port.

9. Free-turbine turboshaft - Wikipedia

   en.wikipedia.org/wiki/Free-turbine_turboshaft

   The compressor spool, turbine and compressor, is in green. The free power turbine is in purple. A free-turbine turboshaft is a form of turboshaft or turboprop gas turbine engine where the power is extracted from the exhaust stream of a gas turbine by an independent turbine, downstream of the gas turbine. The power turbine is not mechanically ...