enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Annular cutter - Wikipedia

   en.wikipedia.org/wiki/Annular_cutter

   Annular cutters can also be used to make holes in pipes and tubes without dimpling and deburring. To make a hole in a tube or pipe easily an annular cutter should be used with a magnetic base drilling machine and a tube/pipe clamping device. The tube clamping device is a metallic device that is clamped on the tube with an adjustable chain.

3. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1] When drilling larger holes, where the drill bit is wider than the indentation produced by a center punch, the drilling of a pilot hole is usually needed. An automatic center punch operates without the ...

4. Screw extractor - Wikipedia

   en.wikipedia.org/wiki/Screw_extractor

   The screw is drilled out with the appropriate drill and drill bushing. The extractor is then hammered into the hole with a brass hammer, because a steel hammer is more likely to cause the extractor to break. The appropriate special nut is then attached to the end of the extractor. The nuts can then be turned with a wrench to remove the screw. [1]

5. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   Chucking reamers, or machine reamers, are the most common type of reamer used in lathes, drill presses, and screw machines that provide a smooth finish to the hole. They come in a variety of flutes and cuts (e.g. right hand cut, left hand spiral, straight flute) as well as different shank types.

6. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   A bit used to enlarge an existing hole is called a core drill bit. The existing hole may be the result of a core from a casting or a stamped (punched) hole. The name comes from its first use, for drilling out the hole left by a foundry core, a cylinder placed in a mould for a casting that leaves an irregular hole in the product. This core drill ...

7. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   First a pilot hole is drilled slightly larger than the screw of the knockout punch. Then the die is placed on the screw and the screw is inserted into the pilot hole. The screw is then threaded into the punch and the screw tightened until the punch is drawn completely through the sheet metal. [2] The manual system uses a screw that has a ...