Search results
Results from the WOW.Com Content Network
In addition to carrying analog RGB video, the connector supports analog stereo audio signals (input and output), Apple Desktop Bus (ADB), and S-video input. [4] Because the AudioVision 14 Display has front-mounted connectors for ADB and audio and video, a single consolidated cable and proprietary connector was used to simplify the connection to the computer and reduce cable clutter.
An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.
Where BNC is used, available as 3 connectors with Sync on Green, or 5 connector Red / Green / Blue / Horizontal Sync / Vertical sync. Mac-II/Quadra DA15F: 1152 × 870 @ 75 [8] Macintosh: Mac-DA15F and Sun-13W3 were similar in capability to VGA. Some Sun machines used 4 or 5 BNC connectors to transfer video signal. 1990: 13W3 DB13W3: 1152 × 900 ...
Apple Desktop Bus (ADB) is a proprietary [1] bit-serial peripheral bus connecting low-speed devices to computers. It was introduced on the Apple IIGS in 1986 as a way to support low-cost devices like keyboards and mice, enabling them to be connected together in a daisy chain without the need for hubs or other devices.
This connector may have been chosen to avoid confusion with the monitor port on early Macintoshes, which also uses a DA-15. [3] The connector locks into position using two clips or hooks on the sides of the connector outside of the shell which automatically clicks on when plugged in, and can be removed by pulling back on a sliding sheath over ...
MII connector on a Sun Ultra 1 Creator workstation. The media-independent interface (MII) was originally defined as a standard interface to connect a Fast Ethernet (i.e., 100 Mbit/s) medium access control (MAC) block to a PHY chip. The MII is standardized by IEEE 802.3u and connects different types of PHYs to MACs.
The network controller implements the electronic circuitry required to communicate using a specific physical layer and data link layer standard such as Ethernet or Wi-Fi. [a] This provides a base for a full network protocol stack, allowing communication among computers on the same local area network (LAN) and large-scale network communications through routable protocols, such as Internet ...
DB13W3 (13W3) is a style of D-subminiature connector used for analog video interfaces. The 13 refers to the total number of pins, the W refers to workstation and the 3 refers to the number of high-frequency pins. The connector was something of a pseudo-standard for high-end graphical workstations from the early 1990s to the early 2000s.