Search results
Results from the WOW.Com Content Network
The pitch of a roof is its vertical 'rise' over its horizontal 'run’ (i.e. its span), also known as its 'slope'. In the imperial measurement systems, "pitch" is usually expressed with the rise first and run second (in the US, run is held to number 12; [1] e.g., 3:12, 4:12, 5:12). In metric systems either the angle in degrees or rise per unit ...
Bonnet roof: A reversed gambrel or Mansard roof with the lower portion at a lower pitch than the upper portion. Monitor roof: A roof with a monitor; 'a raised structure running part or all of the way along the ridge of a double-pitched roof, with its own roof running parallel with the main roof.' Butterfly roof (V-roof, [8] London roof [9]): A ...
TPO roofing systems feature strong seams that are heat-welded, providing superior seam strength and reducing the risk of leaks compared to other roofing systems with adhesive or tape seams. A TPO roof system can be fully adhered, mechanically fastened, or ballasted, although TPO roof systems are rarely ballasted, since the ballast covers up the ...
The first of the cooling load factors used in this method is the CLTD, or the Cooling Load Temperature Difference. This factor is used to represent the temperature difference between indoor and outdoor air with the inclusion of the heating effects of solar radiation. [1] [5] The second factor is the CLF, or the cooling load factor.
A warm roof is a roof that is not ventilated, [9] where the insulation is placed in line with the roof pitch. [10] A hot roof is a roof designed not to have any ventilation and has enough air-impermeable insulation in contact with the sheathing to prevent condensation [11] such as when spray foam insulation is applied directly to the under-side ...
The pitch of a cricket is sometimes the same as the rest of the roof, but not always. For Steep-slope roofs, it is most common to have the cricket pitch to be equal to or less than the main roof, however for low-slope or flat roofs, it is more common to see the cricket be at least 50% greater slope than the roof, to minimize ponding.
roof load; wind load; Previously, it has been shown that the limit state design/load and resistance factor design (LRFD) and permissible stress design/allowable strength design (ASD) can produce significantly different designs of steel gable frames. [3] There are few situations where ASD produces significantly lighter weight steel gable frame ...
Asphalt roll roofing or membrane is a roofing material commonly used for buildings that feature a low sloped roof pitch in North America. The material is based on the same materials used in asphalt shingles ; an organic felt or fiberglass mat, saturated with asphalt , and faced with granular stone aggregate.