Search results
Results from the WOW.Com Content Network
Laurell Technologies WS-400 spin coater used to apply photoresist to the surface of a silicon wafer. Spin coating is a procedure used to deposit uniform thin films onto flat substrates. Usually a small amount of coating material in liquid form is applied on the center of the substrate, which is either spinning at low speed or not spinning at all.
There are four basic parameters that are involved in spin coating: solution viscosity, solid content (density), angular speed, and spin time. [13] A range of thicknesses can be achieved by spin coating. Most commonly the thicknesses range from 1-200 μm. The main properties that affect the thickness of the film are viscosity and spin speed.
A conversion coating is a chemical or electro-chemical treatment applied to manufactured parts that superficially converts the material into a thin adhering coating of an insoluble compound. These coatings are commonly applied to protect the part against corrosion , to improve the adherence of other coatings, for lubrication , or for aesthetic ...
Paintless dent repair can be a very beneficial repair given that the damage qualifies. It can save the factory finish of a vehicle which cannot be replicated nor reproduced. However, PDR does not replace a traditional body repair shop. Factors such as paint damage, stretched metal or an already re-painted panel can inhibit the success of a PDR ...
Modern automobile paint is applied in several layers, with a total thickness of around 100 μm (0.1mm). Paint application requires preparation and primer steps to ensure proper application. A basecoat is applied after the primer paint is applied. Following this, a clearcoat of paint may be applied that forms a glossy and transparent coating.
Spraying. The coating material is applied to the parts' surface using a spray gun. This can be done manually or in a fully automated spraying facility (this process is used for larger or unwieldy parts, also termed rack parts, as they are brought into the coating process on a rack). Dip-spinning. The parts get loaded into a basket.
The first self-cleaning glass was based on a thin film titania coating. [3] The film can be applied by spin coating of organo-titanate chelated precursor (for example titanium iso-tetrapropoxide chelated by acetylacetone), followed by heat treatment at elevated temperatures to burn the organic residues and to form the anatase phase.
From Wikipedia, the free encyclopedia. Redirect page