enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Sand casting - Wikipedia

    en.wikipedia.org/wiki/Sand_casting

    Sand casting, also known as sand molded casting, is a metal casting process characterized by using sand—known as casting sand—as the mold material. The term "sand casting" can also refer to an object produced via the sand casting process. Sand castings are produced in specialized factories called foundries. In 2003, over 60% of all metal ...

  3. Casting - Wikipedia

    en.wikipedia.org/wiki/Casting

    Lost-foam casting – Type of evaporative-pattern casting process; Lost-wax castingProcess by which a duplicate metal sculpture is cast from an original sculpture; Molding (process) – Shaping a liquid or plastic material by making it conform to a more rigid mold; Plaster casting (process) [18] - Sand casting process with use of plaster ...

  4. Pattern (casting) - Wikipedia

    en.wikipedia.org/wiki/Pattern_(casting)

    In casting, a pattern is a replica of the object to be cast, used to form the sand mould cavity into which molten metal is poured during the casting process. Once the pattern has been used to form the sand mould cavity, the pattern is then removed, molten metal is then poured into the sand mould cavity to produce the casting.

  5. Molding sand - Wikipedia

    en.wikipedia.org/wiki/Molding_sand

    Sand casting is one of the earliest forms of casting practiced due to the simplicity of materials involved. It still remains one of the cheapest ways to cast metal because of that same simplicity. Other methods of casting, such as those using shell molds , boast higher quality of surface finish but have a higher cost.

  6. Cope and drag - Wikipedia

    en.wikipedia.org/wiki/Cope_and_drag

    The pattern is a model of the desired casting. Talcum powder is often dusted over the pattern to aid in the removal of the pattern. Sand is sifted over the pattern until the model is covered by a few inches of sand. More sand is then dumped into the drag, and rammed with a wooden wedge, or mechanically vibrated to pack the sand down.

  7. DISAMATIC - Wikipedia

    en.wikipedia.org/wiki/DISAMATIC

    A molding sand mixture, usually green sand or bentonite, is blown into a rectangular steel chamber using compressed air. The molding sand is then squeezed between two patterns, which are on the two ends of the chamber. After squeezing, one of the chamber plates swings open and the opposite plate pushes the finished mold onto a conveyor.

  8. Metal casting - Wikipedia

    en.wikipedia.org/wiki/Metal_casting

    Molten metal before casting Casting iron in a sand mold. In metalworking and jewelry making, casting is a process in which a liquid metal is delivered into a mold (usually by a crucible) that contains a negative impression (i.e., a three-dimensional negative image) of the intended shape.

  9. Ablation casting - Wikipedia

    en.wikipedia.org/wiki/Ablation_casting

    Ablation casting is a sand casting process that uses water to wash away the mold while the metal solidifies. This process produces castings with high mechanical properties, reduced defects, and a fine microstructure. Here are some steps in the ablation casting process: