Search results
Results from the WOW.Com Content Network
A fan controller with LEDs indicating fan status and potentiometers and switches to control fan speeds. Another method, popular with PC hardware enthusiasts, is the manual fan speed controller. They can be mounted in an expansion slot or a 5.25" or 3.5" drive bay or come built into a computer's case. Using switches or knobs, attached fans can ...
This switch is often integrated into the room thermostat and can be manually set or automatically controlled by a digital room thermostat. For automatic fan speed and temperature control, Building Energy Management Systems are employed. The fan motors commonly used in these units are typically AC Shaded Pole or Permanent Split Capacitor motors.
4-Wire PWM Controlled Fans Specification v1.3 – Intel; 3-Wire and 4-Wire Fan Connectors – Intel; 3-Wire and 4-Wire Fan Pinouts – AllPinouts; How PC Fans Work (2/3/4-wire) – PCB Heaven; Why and How to Control (2/3/4-wire) Fan Speed for Cooling Electronic Equipment – Analog Devices; PWM Fan Controller project – Alan's Electronic Projects
A finned air cooled heatsink with fan clipped onto a CPU, with a smaller passive heatsink without fan in the background A 3-fan heatsink mounted on a video card to maximize cooling efficiency of the GPU and surrounding components Commodore 128DCR computer's switch-mode power supply, with a user-installed 60 mm cooling fan.
Portable fan heater A Japanese kerosene fan heater that burns kerosene for fuel. It contains an electric fan and computer controls. Electric fan heater. A fan heater, also called a blow heater, is a heater that works by using a fan to pass air over a heat source (e.g. a heating element). [1]
These sense the air temperature using the differential expansion of two metals to actuate an on/off switch. [14] Typically the central system would be switched on when the temperature drops below the setpoint on the thermostat, and switched off when it rises above, with a few degrees of hysteresis to prevent excessive switching.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
After the control of air flow and temperature was standardized, the use of electromechanical relays in ladder logic to switch dampers became standardized. Eventually, the relays became electronic switches, as transistors eventually could handle greater current loads. By 1985, pneumatic controls could no longer compete with this new technology ...