Search results
Results from the WOW.Com Content Network
Some operating systems, notably Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10, do not configure themselves to load the AHCI driver upon boot if the SATA controller was not in AHCI mode at the time the operating system was installed. Although this is an easily rectifiable condition, it remains an ongoing issue with the AHCI ...
The older "Intel Matrix RAID" is supported under Microsoft Windows XP. Linux supports Matrix RAID and Rapid Storage Technology (RST) through device mapper, with dmraid tool, for RAID 0, 1 and 10. And Linux MD RAID, with mdadm tool, for RAID 0, 1, 10, and 5. Set up of the RAID volumes must be done by using the ROM option in the Matrix Storage ...
[4] [5] Linux kernels support AHCI natively since version 2.6.19, and FreeBSD fully supports AHCI since version 8.0. Windows Vista and Windows 7 also natively support AHCI, but their AHCI support (via the msahci service) must be manually enabled via registry editing if controller support was not present during their initial install.
For a short time in March 2010, users were led to believe that the Intel Rapid Storage Technology (RST) 9.6 (and later) drivers in Windows 7 supported TRIM on RAID volumes, but Intel later clarified that TRIM was supported for the BIOS settings of AHCI mode and RAID mode, but not if the drive was part of a RAID volume.
SRT is managed by Intel Rapid Storage Technology software version 10.5 or later, [2] and implemented both in its device driver and in the Z68 motherboard's firmware . It is available only when the (integrated) disk controller is configured in RAID mode (but not AHCI or IDE modes) by implementing a style of RAID 0 striping.
4 What is the advantage if AHCI mode was used in SATA? 5 comments. 5 Warning relevant? 8 comments. 6 add Linux support section? 1 comment. 7 neutrality. 3 comments.
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
It often implements hardware RAID, thus it is sometimes referred to as RAID controller. It also often provides additional disk cache . Disk array controller is often ambiguously shortened to disk controller which can also refer to the circuitry responsible for managing internal disk drive operations.