Search results
Results from the WOW.Com Content Network
The Stratocaster set of Vintage Noiseless pickups comes packaged with two 1 MΩ potentiometers ("pots") and a 0.022 μF capacitor for tone controls, [11] one 500 kΩ pot for volume control, a 680 pF capacitor and a 220 kΩ resistor for a treble bleed circuit, [12] and a wiring diagram. [13]
A diagram showing a wiring modification for a Les Paul or a similar electric guitar with two humbuckers. Wiring schemes using four push-pull pots for additional pickup combinations were made popular by Led Zeppelin guitarist Jimmy Page and later produced as a signature model by Gibson. The modification shown in this diagram is an evolution of ...
Schematic diagram. An induction coil consists of two coils of insulated wire wound around a common iron core (M). [1] [7] One coil, called the primary winding (P), is made from relatively few (tens or hundreds) turns of coarse wire. [7] The other coil, the secondary winding, (S) typically consists of up to a million turns of fine wire (up to 40 ...
as 51, with choke coil 59 AC out, rectifier in, light switch 51, 51-, 51a 59a charge, rotor out 59 64 generator control light Generator, voltage regulator; 61 charge indicator (charge control light) B+ battery + 51, 51B+, B+30, B+51 B- battery - 31B- D+ dynamo/alternator diode+ D- dynamo/alternator diode- DF dynamo field DF1 dynamo field 1 DF2
This page was last edited on 27 November 2019, at 03:27 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
A coil with a core which is a straight bar or other non-loop shape is called an open-core coil. This has lower magnetic field and inductance than a closed core, but is often used to prevent magnetic saturation of the core. A coil without a ferromagnetic core is called an air-core coil. [14]
A loading coil or load coil is an inductor that is inserted into an electronic circuit to increase its inductance. The term originated in the 19th century for inductors used to prevent signal distortion in long-distance telegraph transmission cables.
A choke usually consists of a coil of insulated wire often wound on a magnetic core, although some consist of a doughnut-shaped ferrite bead strung on a wire. The choke's impedance increases with frequency. Its low electrical resistance passes both AC and DC with little power loss, but its reactance limits the amount of AC passed.