Ads
related to: pressure gauge calibration equipment
Search results
Results from the WOW.Com Content Network
In 1996 DH-Budenberg was established from the merger of Desgranges & Huot from France (known widely as "DH") and the calibration division of Budenberg Gauge Co. Budenberg had been manufacturing pressure calibration equipment - deadweight testers and calibrators - since the 1920s.
A dead weight tester (DWT) is a calibration standard method that uses a piston cylinder on which a load is placed to make an equilibrium with an applied pressure underneath the piston. Deadweight testers are secondary standards which means that the pressure measured by a deadweight tester is defined through other quantities: length, mass and time.
Piston-type gauges counterbalance the pressure of a fluid with a spring (for example tire-pressure gauges of comparatively low accuracy) or a solid weight, in which case it is known as a deadweight tester and may be used for calibration of other gauges.
As an example, a manual process may be used for calibration of a pressure gauge. The procedure requires multiple steps, [ 12 ] to connect the gauge under test to a reference master gauge and an adjustable pressure source, to apply fluid pressure to both reference and test gauges at definite points over the span of the gauge, and to compare the ...
The combination R-G-B = HH-HV-VV combines radar images of waves sent and received horizontally (HH), sent horizontally and received vertically (HV) and sent and received vertically (VV). The calibration of such instruments is done by imaging objects (calibration targets) whose radar brightness is known.
Pages in category "Pressure gauges" The following 23 pages are in this category, out of 23 total. This list may not reflect recent changes. ...
Ads
related to: pressure gauge calibration equipment