enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Electrical ballast - Wikipedia

   en.wikipedia.org/wiki/Electrical_ballast

   [1] [3] To prevent this, fluorescent tubes are connected to the power line through a ballast. The ballast adds positive impedance (AC resistance) to the circuit to counteract the negative resistance of the tube, limiting the current. [1] Several American magnetic ballasts for fluorescent lamps. The top is a rapid start series autoregulator ...

3. 0-10 V lighting control - Wikipedia

   en.wikipedia.org/wiki/0-10_V_lighting_control

   Dimming fluorescent ballasts and dimming LED drivers often use 0–10 V control signals to control dimming functions. In many cases, the dimming range of the power supply or ballast is limited. If the light output can only be dimmed from 100% down to 10%, there must be a switch or relay available to kill power to the system and turn the light ...

4. Fluorescent lamp - Wikipedia

   en.wikipedia.org/wiki/Fluorescent_lamp

   Fixtures for flashing lights (such as for advertising) use a ballast that maintains cathode temperature when the arc is off, preserving the life of the lamp. The extra energy used to start a fluorescent lamp is equivalent to a few seconds of normal operation; it is more energy-efficient to switch off lamps when not required for several minutes.

5. Compact fluorescent lamp - Wikipedia

   en.wikipedia.org/wiki/Compact_fluorescent_lamp

   The dimming range of CFLs is usually between 20% and 90%, [59] [unreliable source] but many modern CFLs have a dimmable range of 2% to 100%, more akin to that of incandescent lights. There are two types of dimmable CFL on the market: Standard dimmable CFLs, and "switch-dimmable" CFLs.

6. Dimmer - Wikipedia

   en.wikipedia.org/wiki/Dimmer

   This circuit is called a leading-edge dimmer or forward phase dimming. Waveform of the output voltage of a thyristor dimmer set for 60 volts RMS output, with 120 V input. The red trace shows the output device switching on about 5.5 ms after the input (blue) voltage crosses zero.

7. GU24 lamp fitting - Wikipedia

   en.wikipedia.org/wiki/GU24_lamp_fitting

   The design was initiated by the U.S. EPA and the Lighting Research Center in 2004, in order to facilitate the deployment of compact fluorescent light bulbs with replaceable ballasts. [ 1 ] The GU24 fitting is compliant with a 2008 ruling by the California Energy Commission under Title 24 ( California Building Standards Code ) to require high ...