Search results
Results from the WOW.Com Content Network
By the 1850s, railroad operating rules, often printed as pamphlets or on the back of a time card, had evolved to near universal application. On April 14, 1887 representatives of 48 railroads voted for the adoption of what is now known as the Standard Code of Operating Rules (SCOR), published by the AAR. Thus, all railroad rule books in North ...
The balance lever coupling, also central buffer coupling with two screw coupling, is a coupler commonly used on narrow gauge railroads with tight curves. By swapping the pulling and pushing devices, the standard screw coupling used on standard gauge railroads became a center buffer coupling with one screw coupling on each side of the buffer.
A switch stand (points lever or ground throw) is a lever and accompanying linkages to align the points of a switch by hand. The lever and its accompanying hardware is usually mounted to a pair of long ties (sleepers) that extend from the switch at the points. They are often used in a place of a switch motor on less frequently used switches.
A mechanical lever frame inside the signal box at Knockcroghery in Ireland Waterloo station A signalbox, LSWR (Howden, Boys' Book of Locomotives, 1907). Mechanical railway signalling installations rely on lever frames for their operation to interlock the signals, track locks [1] and points to allow the safe operation of trains in the area the signals control.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
To the right of the turret was a selection lever, which would allow the turret to output foam or water depending on the turret operator's selection. A diagram of the MB-5's front hose reel. The handline was designed by Ardmore Mfg Co and was fed by a 150 pounds per square inch (1,000 kPa) centrifugal pump (built by Waterous Pump Co). [3]
Metal fire-resistance rated door with a lockset consisting of a locking latch bolt operated by lever handle with an escutcheon that encompasses the locking mechanism.. A lockset (alternatively lock set) is the hardware and components that make up the locking or latching mechanism that can usually be found on a door or other hinged object but can also include sliding doors and dividers. [1]
It is controlled by a handle and sprung trigger at the top, and pivots at the bottom to pass between two notched sector plates. The reversing rod, which connects to the valve gear, is attached to the lever either above or below the pivot in an alignment that gives good leverage. A square pin is arranged to engage with notches cut in the plates ...